| |
D-Link Wizard Setup for PPPoE, Static, and Dynamic
D-Link Wizard Setup for PPPoE, Static, and Dynamic
DI-614+
Open your browser and type 192.168.0.1 and this should open the logon page for the router.
Type admin for the username and leave the password blank. Click OK.
On the left hand side of the screen click on Wizard and you will see the following screens.
This screen shows you the 5 steps that you will be taking. Click next
This screen is where you can change the password for the router. Click next
Here you will set the time zone that you are in. Click next.
PPPoE Setup
This walk through will show you all 3 of these options. We will start with PPPoE. Click next.
Type in your username and password, retype password.
You’re SSID and channel is assigned by the user, what ever you want. Click next.
Click disabled and then next.
Static Setup
Select Static and then next.
These are the only 2 screens that are different from PPPoE shown earlier in this walk through. All of the info on this page has been supplied to you by DSLExtreme. Fill it in and click on next.
Dynamic IP Address
Select Dynamic IP Address and click next.
Created On: 3/28/2005 1:57:00 PM
Last Modified On: 8/27/2009 2:20:00 PM
Article ID: 10792
Viewed 8,082 times
|
|